- Guitar Nut and Saddle Sander
- Quality contruction - aluminum body with brass knobs
- Accomadate both acoustic saddles and nuts
- Helps sand bottom square
- Easy to use
The Nut and Saddle Sander is designed to hold a nut or an acoustic saddle so you can easily create a square bottom surface.
After installing the nut or saddle, slide the sander across a strip of sandpaper attached to a flat surface. You are all done when all wheels start to turn. Use the two screws on top to remove the precise amount of material. Those two knobs can be adjusted independently to precisely adjust the tilt of an acoustic bridge saddle.
This tool is typically used after shaping a saddle or nut to its final shape.
MM or CM to Fractions of Inches
-
Guitar Nut and Saddle Sander
Works like a charm and the price can't be beat when comparison shopping. I'm not sure how we went without this particular tool in our shop for as long as we did. If you don't have one get it....you won't be sorry! The only negative observation is that the side thumb screws utilize clock-wise wound springs and we found that when tightening they tend to spread at the base and can hit the sanding surface. We rectified this with replacement springs we had on hand in the shop. The fine depth adjustment is accurate and we've been able to save considerable time for our nut installs on our line of production replacement necks we manufacture.
-
Guitar Nut and Saddle Sander
good quality
-
nut and saddle sanderf
I work frequently with vintage bone and fossil ivory, which can be brittle. Assuming the saddle slot is properly done flat, an uneven saddle bottom can cause the saddle to crack under tension True, not very often, but it has happened (and all that work down the drain). More common is a saddle not making full contact with the saddle slot bottom with the concurrent loss of tone. Plus this one is MUCH less expensive than the other place.
-
GREAT TOOL, EVEN BETTER PRICE
This is the same tool that other web-sites are selling for $175, the EXACT SAME TOOL. The TOOL itself is GREAT, takes a lot of time off of sanding down a NUT to the correct height. After sanding down a ZER-GLIDE NUT that took over 45 minutes, I had to buy this tool. I will NEVER WASTE my time sanding down a NUT without this TOOL.
-
Pretty Fucking Nice
Would have given it 5 but that would have been too easy.
