- Flush cutting end nip pliers
- FastCap Brand
- Hardened Steel that can easily cut Nickel/Silver fretwire. Not Recommended for Stainless Steel or EVO fretwire.
- These will cut fret wire very close to the fretboard.
- Medium size that easily fit in hand for easy continues use. Total length 6 3/8" (163mm). Jaw width 1" (25mm)
These flush cutting pliers can be used in a variety of different applications, including, trimming the edge of binding/veneers and soft metals.
MM or CM to Fractions of Inches
-
Best pliers for fret ends
These work great for cutting fret ends. The way they are constructed is useful for cutting the fret over hang without pulling it out of the slot. Great customer service at PLT as well!
-
great!
cant wait to use it.
-
FastCap Fret Cutters
Only used on two jobs so far. Teeth cut with minimum pressure when used on NS frets. Great for a low cost, starter set of Nips.
-
Not for Stainless Frets
I'm sure these are GREAT for nickel frets. DO NOT try these with stainless steel frets. Ruined them on the first few snips.
-
Just okay.
The cutting edge is not very hard. Already have a couple of nicks in the cutters from the fret wire, & I've only used these on fret wire. The bolt holding the jaws together gets in the way when you are up against the fingerboard requiring you to angle the cutters. Cannot recommend.
