- 50mm P-90 Pickup Bobbins
- Black
- 50mm center to center pole spacing
- Appox. 1/4" (6.2mm) space for winding magnet wire
- Overall dimensions 3 3/16" (80.6mm) x 1 3/16" (30mm) x 3/8" (9.4mm) thick
- Qty 2
MM or CM to Fractions of Inches
-
Good standard
These bobbins were injection molded so you'll want to sand all of the sharp edges on the seams inside the bobbin. The pole piece holes are also a bit tight, so tapping the holes will help put the screws through. Other than those very standard practices to prep for winding, these are just fine.
-
Good stuff
Worked well, had to spot sand a few high spots, normal for any bobbin though. Plan to reorder more.
