- Flatwork Eyelets for .090" thick flatwork
- Tinned Brass
- 3/32"(.090") diameter - 2.28mm
- Overall Length - .137" (3.5mm)
- Quantity 50
MM or CM to Fractions of Inches
-
Just what you expect
These worked well. They fit well in a hole drilled with a 3/32" drill bit. I used a craft eyelet setter which is meant for larger eyelets, but it still got the job done. They are well tinned and solder readily.
-
They work...
These eyelets will get the job done, but in my opinion they are not the ideal dimensions for making fender style pickups. They are too tall and the hole is a little too small. When you press them into .09" fiber they get very squashed, making the hole even smaller and the edges become jagged. I've tried using the eyelet pressing tool supplied by PLT-S and my result wasn't much better. I prefer a shorter eyelet for these reasons, and a bigger hole so that it's easy enough to put in two 22awg wires without having to worry about snapping the magnet wire when I'm making tele bridge pickups...
