- Aftermarket part(not genuine PRS part)
- Fits most import PRS SE model guitars. Some PRS SE models do use the USA sized truss rod cover. IT IS VERY IMPORTANT THAT YOU CHECK THE SIZE BEFORE PLACING YOUR ORDER.
- 3 ply blank in black(1.5mm thick with .5mm black,.5mm white and .5mm black)
- Beveled edge
- No mounting screw is included
**Please note that the truss rod cover will come with a thin protective film on its face**
MM or CM to Fractions of Inches
-
PRS truss rod cover for the import model
The USA cover is shorter than this version and single ply black. However the USA Cover had shrunk a bit and didn’t quite touch the nut. So I shortened this import model and installed it on the USA PRS guitar. Blasphemy perhaps, but having refretted the guitar with EVO wire and replacing the stock nylon nut with bone it was all about moving forward. The cover looked nice even if it could have been a little thicker.
-
Much Better Than Stock PRS SE Part
As stated, much higher quality than the single ply Asian made part that comes stock on the PRS SE Models. Especially nice on a Bernie Marsden Signature for that classic LP look. Excellent as always.
