- Barbed half moon truss rod washer
- Steel
- Larger Gibson® Reissue size used on some Gibson Historic models
- Approx. .72"(18.3mm) x .43"(10.8mm) x .100"(2.6mm) thick with .200"(5.2mm) diameter hole
- Designed to fit standard 3/16" truss rods
- **These will not fit standard Gibson USA model guitar** The truss rod washer were larger in the 50's and early 60's Gibson guitars.
- If you are using this as a replacement for your original washer please check the size before you order!!!
- Qty 1
These are also great for the guitar builder that use a 3/4" truss rod access. Barbed to prevent rotation while tightening truss rod nut.
MM or CM to Fractions of Inches
-
Thickness
Just a little too thick: Thinner would be better !
